I ordered a whole set of interior LEDs and like them. In the event you wanted to improve your rig, the following is a how to. Bear with me…the following is my first how to heh. Notice: Verify the polarity of the LED and mark them which way they perform. In the event they do not light turn them over / rotate.
The Tools:
1 Pocket screw driver (flat end was useful)
1 Philips screw driver med. Length.
1 Miniature 45 degree needle nose pliers
1 Knife (not pictured)
1 Sharpie (not pictured)
I started with the door lights. It was easy I place the pocket screw car owner against the backside of the housing (closest to outside edge) and just pried till they popped out. Pulled out the connector, and the old 194 bulb, mounted the LED replacement noting the polarity. Tested when the LED lights up, it did so I was done. Found the 194 led base is a little bit bigger than the standard bulb. So I employed my knife and cut out a smaller amount to make the diameter larger.
In that case I determined to do the roof lights. Once again using the pocket screw driver I taken away the housing lenses. At the rear of the white center lens generally there is a bulb and two Philips screws which hold the light up to the roof and also act as a ground. Usually do not take out the light yet! Require the LEDs and figure out which way they need to go to light up. Indicate the direction with the sharpie. Then I taken off the screws and delivered the light down. I taken out the bulbs. I found it simpler to modify the independent map lights by using the light off the roof than when it was fitted. To change the map lights simply just hook one end then pull to the other and the tabs will produce resistance and continue the LEDs in place. Change left and right map light, build the light back on the roof and put in the center LED. Check out operation. Reinstall plastic housing note that the housings have notches on them. Line them up with the correct side. Repeat for the rear and center dome light.
Following I went onto the front map lights. I do NOT have rear A/c, I have/had a roof console. Again utilizing the pocket screw driver I removed the empty slot for the console. There may be a screw holding it to the roof. There may be also a screw just simply facing the rear view mirror. Take away both Philips screws and bring the map light holder down. Unplug the lights. Split the map lights from the console. 3 Philips screws. Plug the map lights back in and look at LED polarity and mark it. Trust me it makes things less difficult. Insert the pocket screw driver through the light and push on the lens from the interior to push it out. Employing the pliers gently grab the 194 bulb and pull it out. Put in the marked LED. Turn the light on and it should light. If it does not light you may perhaps ought to change the polarity, using the pocket screw driver you can push out the led from inside the housing much like pushing the lens, just push the bulb out. And also you may have to bend the metal contact tabs to make good contact with the LED. Look at the fitment and play with it. Sooner or later they will work. Once they work reinstall the lens by pushing it back. Possibly use some super glue if your lens does not stay. Reassemble the map lights and overhead console. Reinstall.
We found this useful information from tahoeyukonforum.com and to buy LED bulbs, please visit us at www.LEDoption.com, the discount LED bulbs store.
No comments:
Post a Comment