And here is what exactly you may require:
With regard to the Chargers, you will need the following bulbs.
(2) 44mm rigid loop, 9 LED Festoon light (front map lights)
(2) 194 SMT tower LED (rear seat map lights)
(1) 44mm rigid loop, 9 LED Festoon light (rear trunk lighting)
(1) 194 4-star SMT (rear exterior license plate lighting)
You can find no courtesy lights and glove box lighting for the Dodge's. However you can get the glove box lighting and install in your glove box.
And then you could have to have a: (1) 194 SMT tower LED (glove box)
Fitting the bulbs.
Trunks/Hatch door lights
Very much alike the courtesy lamps on the 300 doors. Get rid of the oem festoon light with a soft towel, lamp is very hot. Slide one end of the LED festoon light down the folded socket prong. Smoothly unfold the other folded socket prong and work the other end of the LED festoon light bulb down. After it is snug in place and illuminated. Flick it a few times to make sure it is tight. Fold straight down the unfolded ending of the socket prong.
Rear exterior license plate lights. (2) for the 300's (1) for the Magnum and Chargers.
1. Work with a small handle phillips screw car owner to remove the license plate housing screws.
2. Take the overall lens down and out. Twist the 194 light socket loose, out of the back of the clear lens.
3. Draw out the 194 oem light. Stick in the 194 4-star SMT bulb straight into the 194 socket. Push it in as far as it will go.
4. Go first turn on your parking lights to check and make sure the license plate light illuminates. In case it would not, you may possibly get the 194 in back (reverse polarity). Pull the Light bulb out move it in your hand. After that reinstall the 194. It should light up.
We found this useful information from chargerforums.com and to buy LED bulbs, please visit us at www.LEDoption.com, the discount LED bulbs store.
No comments:
Post a Comment