Installation Guide for Dodge Charger LED Front Map Lights

Here's just what you'll require:
For the particular Chargers, you may need the following light bulbs.
(2) 44mm rigid loop, 9 LED Festoon bulb (front map lighting)
(2) 194 SMT tower LED (rear seat map lighting)
(1) 44mm rigid loop, 9 LED Festoon bulb (rear trunk light)
(1) 194 4-star SMT (rear exterior license plate light)

You can find no courtesy lights and glove box lamps for the Dodge's. Nonetheless you can buy the glove box light and install in your glove box.
Then you will need a: (1) 194 SMT tower LED (glove box)

Putting in the lamps.

Front Map Lights.
1. From the click on/off end of the clear lens. Use a tiny jewelry/glasses flat head screw driver. Very carefully wedge it into the on/off end of the lens and pry that end of the lens straight down. It may seem such as it will snap, don't worry. The backside end of the lens is held in place by 2 notches. Pull down with your fingers and it should pop free. Occasionally it pops free when you are wedged in having the flat head and taking down.

2. Remove the rectangular metal reflector. I use a set of pliers, simply because the metal may be hot. You will certainly be left with the oem light bulb and the rear refector, at the rear of the lamp.

3. I work with a small hand towel to attain up and get rid of the oem light bulb, it will be very hot.

4. Consider your pliers and acquire a grip on the rear reflector piece, nearest to the roof. You will really need to pull and twist to get the rear reflector to pop off of its 2 moutning points. At this point. You might throw away each metal reflectors, you will probably not need all those.

5. Before fitting the 44mm LED bulbs. Head to the socket prongs that hold the bulb in place. As soon as you remove the oem lamp, the prongs are likely to un-bend a little. So consider your fingers and lightly re-squeeze them a bit stronger. And then pop in your LED lamp and rotate it until all the 9 led lights are attempting straight down. You can put your hand under the lighting to support discover where it's aiming.

6. Get the clear lens and line it up with the 2 notches in back. Take all those directly into place. Next pop the click on/off end again up into place.

We found this useful information from chargerforums.com and to shop LED bulbs, please visit us at www.LEDoption.com, the discount LED bulbs store.