And here is exactly what you may need:
Regarding the Chargers, you will probably need the following light bulbs.
(2) 44mm rigid loop, 9 LED Festoon light bulb (front map lamps)
(2) 194 SMT tower LED (rear seat map lighting)
(1) 44mm rigid loop, 9 LED Festoon light (rear trunk light)
(1) 194 4-star SMT (rear exterior license plate light)
There's no courtesy lights and glove box lights for the Dodge's. Although you can get the glove box lighting and install in your glove box.
And then you will require a: (1) 194 SMT tower LED (glove box)
Rear seat map lighting (similar to the front map lights)
1. From the click on/off end of the clear lens. Work with a tiny jewelry/glasses flat head screw driver. Carefully wedge it into the on/off end of the lens and pry that end of the lens down. It may possibly seem like it will take, don't be concerned. The other end of the lens has a tab on it and basically pull the lens, soon after popping it from the on/off end and it will appear.
2. You need to right now see the oem 194 bulb and a rear reflector.
3. I work with the smaller flat go to pop the 194 bulb out. I own a towel in the other hand to catch the hot 194 LED bulbs.
4. Never take away the rear reflector on the rear map lighting.
5. Before the installation of the 194 tower SMT lamps. Check out the socket prongs that keep the light bulb in place. While you take away the oem 194 light bulbs, the prongs usually tend to un-bend a little. So get your fingers and casually re-squeeze them a bit stronger.
6. Once the fresh 194 LED is fitted. Flick it a few times to make sure it keep on. If it doesn't. Move the led bulb out and re-squeeze the socket prongs. When the light stays on. Re-mount the clear lens.
7. Have the end of the lens by using the wedge on it and put that directly into place. After that push in the on/off click end and you are completed.
We found this useful information from chargerforums.com and to shop LED bulbs, please visit us at www.LEDoption.com, the cheap LED bulbs store.
No comments:
Post a Comment